The broken pulp, juice and peel enter the coconut Juicer through the hopper, and the pitch decreases with the increase of the diameter of the bottom of the screw in the direction of slag outlet. When the material is pushed forward by the screw, the volume of the screw cavity is reduced, forming the extrusion of the material. The rotation direction of the screw spindle is clockwise from the feeding hopper to the slag trough. When the raw material is added into the feeding hopper and pressed by the screw, the squeezed juice flows into the juice rack at the bottom through the filter screen, while the waste is discharged through the annular gap formed between the screw and the conical part of the pressure regulation, and the size of the gap can be adjusted by the axial movement of the pressure regulation head. Use it clockwise (from the slag chute of the equipment to the hand wheel bearing seat at the end of the feeding bucket, with the pressure regulating head on the left side, the gap will be reduced, otherwise, the gap will be increased). ）If the gap is too small, part of the slag particles and juice will be extruded together with the juice through the filter screen. Although the juice increased, the quality of the juice decreased relatively, and the size of the gap should depend on the specific process requirements of users. So as to achieve the purpose of automatic separation of juice and slag.