Passion fruit juicer is a multi-purpose juicer, which can be used not only for fruits, but also for vegetables. Generally speaking, it is mainly suitable for processing all kinds of berries, nuts and vegetables.

 

1. It is composed of crushing and screw juicer;

 

2. It is widely used to extract juice from apple, pear, carrot, aloe and cactus;

 

3. Complete the crushing, juicing and slag removal processes of berries, nuts and vegetables automatically.

Working principle of passion fruit juice extractor:

 

The baixiangguo juice extractor of Jingjiang Weineng machinery is composed of feeding hopper, crushing equipment, front support, screw, filter screen, juice container, rear support, slag trough and other components. The left end of the screw spindle is supported in the rolling bearing seat, the right end is supported in the hand wheel bearing seat, and the motor drives the screw through the three angle belt pulley for operation. Operation principle: the primary component of the equipment is the crushing equipment on the feeding hopper. There are four groups of flying knives and a group of bottom knives on the rotor. The flying knives rotate around their own axis in the fixed bottom knife gap, so that the fruits and vegetables can be crushed by 2-5mm granularity and directly enter the spiral juicing system to improve the juicing effect. The primary component of spiral juice pressing is spiral. The bottom diameter of spiral increases gradually along the direction of slag outlet, while the pitch decreases gradually. When the material is pushed by spiral, the volume of spiral cavity decreases, forming the pressing of material.

 

The rolling direction of the spiral spindle of passion fruit juice extractor is clockwise from the feeding hopper to the slag groove. The material enters the feeding hopper and is pressed under the push of the screw. The squeezed juice flows into the juice container at the bottom through the filter screen, while the waste material is discharged through the empty space formed between the screw and the pressure regulating conical part. The size of the empty space can be adjusted by the movement of the pressure regulating head along the axial direction. When rolling the hand wheel bearing seat from the slag chute to the hopper end, the pressure regulator head will turn to the left, the empty space will shrink, otherwise, the clearance will become larger. Changing the size of the empty space can adjust the resistance of slag discharge, and then change the slag discharge rate. However, if the empty space is too small, under strong extrusion, some slag particles and juice will be extruded through the filter screen together. Although the juice is added, the quality of the juice will decline relatively The size of the open space should be determined according to the user's detailed process requirements.