Features of grape fruit and vegetable crusher produced by Jingjiang Weineng machinery: the hammer is made of wear-resistant stainless steel 304, with wear resistance and impact resistance. Ensure no dust leakage, meet the requirements. Fully sealed design, meet the production requirements. And equipped with open door, convenient for daily maintenance and maintenance. It only needs to be set on the horizontal ground for normal operation without foundation fixation. According to the requirements of customers, the crusher can adjust the required particle size.

 

 

Large grape grains and small mesh will cause the grapes to fall down. Some customers buy the grapes and pull them away without clarifying the size of the grape grains. Later, they have to change the sieve cylinder. Small grape stem crusher start-up problem, assuming that start-up grape stem does not discharge from the tail of the machine, and the grapes do not break the material, that is the power is connected reversely. The normal removal of stem and breakage indicates that the power cord device is correct.

 

 

Spiral quantitative feeding, first remove the stem and then break; the length of the rotary screen is longer, which can be used to deal with a variety of fruit varieties, and the stem with less fruit outside the discharge machine. This process will reduce the broken stem rate of the fruit stem, and the fruit grains with low maturity will be pushed out of the sieve barrel due to the tight connection with the fruit stem, and the spiral distribution of the push rod on the stem shaft will be removed. The diameter and rotation speed of the sieve barrel and the rotation speed of the stem removing shaft constitute the factors of the stem removing function and the fruit content of the fruit stem removing crusher.

 

 

The fruit and vegetable crushing equipment is composed of the side cover of the feeding hopper, the body, the main shaft bearing seat, the motor frame, the discharging hopper, etc. During the operation, the motor drives the spindle to rotate at the same speed through a pair of pulleys, and the spindle is equipped with a flying knife to rotate at high speed. The material falls into the hopper freely from the elevator and is chopped by the high-speed rotating flying knife. Due to the centrifugal force, the material falls into another storage tank from the waist shaped screen, and then is pumped into the next process by the conveying pump.